4 Running the test-suite

4.1 Running the test suite from Prolog

To run tests from the Prolog prompt, first load the program and then run run_tests/0 or run_tests(+Unit).

run_tests

Run all test-units.

run_tests(+Spec)

Run only the specified tests. Spec can be a list to run multiple tests. A single specification is either the name of a test unit or a term <Unit>:<Tests>, running only the specified test. <Tests> is either the name of a test or a list of names. Running particular tests is particularly useful for tracing a test:^{6Unfortunately the body of the test is called through meta-calling, so it cannot be traced. The called user-code can be traced normally though.}

?- gtrace, run_tests(lists:member).

To identify nonterminating tests, interrupt the looping process with Control-C. The test name and location will be displayed.

4.2 Running the test suite from the command line

To run a file's tests from the command line, run the following command, replacing your/file.pl with the path to your file.

swipl -g run_tests -t halt your/file.pl

Prolog will (1) load the file you specify, as well as any modules it depends on; (2) run all tests in those files, and (3) exit with status 0 or 1 depending on whether the test suite succeeds or fails.

If you want to test multiple files, you can pass multiple ..pl files.